This may sound stupid but how do you use the USB to RS485 device to chande the ethernet parameters to 192.168.0.1
I have connected it to the Nano 10 board switched it on and loaded all the drivers successfully on the laptop and it is active on com port 17
I have plugged it in to the laptop and it is connected via twisted pair to the nano board + and - rs485
Thats it I opened the tl6 program and gone through all the various options to connect to server etc and have no response there is absolutely no instructions with the Usb Device software so can any one give me a clue how it works as I was not born with this knowlege