1
Technical support / Re:E10npn+ no special bits
« on: October 18, 2010, 05:31:25 AM »
I just worked it out when I select Edit , I/O Table you can't select the special bits, but if I insert a contact then I can select the special bits.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical support / E10npn+ no special bits
« on: October 18, 2010, 05:25:49 AM »
Hello, I have just purchased an E10 npn starter kit. I am trying to insert a special bit 1 sec clock pulse, but I can't select the special bit option from the I/O table. I'm using Wintrilogi 3.53, when I connect to the plc and check the hardware it says I have a E+13. I have also loaded the program SEQTEST.pe3 which has a 1 sec clock pulse and it works fine.
Pages: [1]