1
Technical support / Lift Control
« on: November 22, 2006, 02:38:52 AM »
I need help in creating a lift control program. I need to design three floor elevator controller using PLC.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical support / Enquire on a Chapter
« on: July 01, 2006, 07:34:35 PM »
I would like to ask about a chapter on the user manual, which is chap 4, where i can find examples on the software ? thanks for reading my topic.
3
Technical support / Re:Programming Help
« on: May 22, 2006, 06:39:06 AM »
Oh ok. i will go try it out. Support thanks alot for yr help. Sorry to trouble you. 
4
Technical support / Re:Programming Help
« on: May 21, 2006, 08:22:34 PM »
oh, but the i already try, it does not work.
Anyway, i don't mind to see yr program, at least i can understand from it. Thanks for yr help.
Anyway, i don't mind to see yr program, at least i can understand from it. Thanks for yr help.
5
Technical support / Programming Help
« on: May 21, 2006, 07:39:06 AM »
I doing a final year project for my sch and i still new to this TRiLOGI.
This is what mine project about: When the postman open at the back of the letter-box, put letters in, sensor 1 will detect, if got letters, the front door LED will light up. If the letter-box is going to be full, will send a sms to the owner telling him/her. Beside this, after every 5 days and still got letters inside, it will also send a sms to the owner. Then it will reset everything.
I know my project is very messy, hope you all understand how it works.
Thanks.
This is what mine project about: When the postman open at the back of the letter-box, put letters in, sensor 1 will detect, if got letters, the front door LED will light up. If the letter-box is going to be full, will send a sms to the owner telling him/her. Beside this, after every 5 days and still got letters inside, it will also send a sms to the owner. Then it will reset everything.
I know my project is very messy, hope you all understand how it works.
Thanks.
Pages: [1]