Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Enertyr

Pages: [1]

Technical support / Load TLServer as a Service

« on: September 06, 2006, 12:44:03 PM »

Is there anyway we can configure or install TLServer as a system service? I seem to get nuisance trips on my PC that cause it to reboot. But the TLServer does not re-enable and I miss out on hours of data logging. And I get no email alerts because TLServer is needed as well.

Terry

Technical support / Remote Access to FileService Directory

« on: February 15, 2006, 12:02:09 PM »

I have a PLC logging to the server as a .CSV file. It defaults to /FileService directory.

I have PortForwarding enabled (9080) to my Server, but is there any way I can get access to the csv file located in /FileService?

(if I HTTP to my address, I do launch the runTrilogi.html. So I know i can get through to /PUBLIC).

Any suggestions?

Technical support / Adding CompactFlash to increase memory

« on: November 12, 2005, 06:02:22 PM »

Your memory option board still doesn't provide sufficient memory capacity I require. The cost of CF and SD memory has come down significantly so is there any way a person can add a compactFlash aux boards to your controllers? I came across this product as one example. e.g. http://www.mikroelektronika.co.yu/english/product/tools/cf.htm

If not, are you considering adding such a package?

Technical support / Converting non-linear Thermistors

« on: September 17, 2005, 10:02:48 PM »

I'm using 10k thermistors to measure temperature in ADC[1] through [5]. Because the output is non-linear, I need a simple way (other than a signal conditioner) to get near accurate temperature readings.

I read somewhere to use a tables (DM

) and interpolating values. Does anyone have sample code on working with tables, extracting the data and interpolating?

Alternately, is there a some other "soft" routine to calculate a reasonable temperature value?