Internet PLC Forum

General => Technical support => Topic started by: shahzad akram on June 12, 2008, 02:33:34 AM

Title: Analog Device
Post by: shahzad akram on June 12, 2008, 02:33:34 AM

sir
   I have 4832 tri-PLC.I want to hook analog device with 0 to10 volt. can you advive me how can i connect with them.

Title: Re:Analog Device
Post by: support on June 12, 2008, 10:24:24 AM

You can use two 10K ohm resistors in series and connect to the 0-10V input, then tap the center of the two series resistor and the voltage will be divided by two, which means 0-5V.

This technique is already described in the PLC's installation guide (white cover thin booklet). Pleas refer to it for the wiring diagram.