Show Posts
1
Technical support / T100MX aplicada a molding injection machines
« on: October 11, 2002, 07:46:24 PM »
I am wanting to apply a PLC T100MX4832 to a Molding Injection Machine that has 2 servovalvulas, 1 transducer of pressure 0-10V, 1transductor of position 0-10V, the servovalvulas they are controlled by cards amplificadoras that you/they receive 3 similar signs that setean speed and pressure of injection of 0-10 V, and load speed also 0-10V, like I can enable 3 output analog exits in the T100MX.
Additionally we want to connect a Graphic HMI, and monitorear the curve of pressure and injection speed, we are planning to use the EZTouch of Automation Direct that has the communication protocol Modbus RTU.
Please send us their comments and suggestions.
Greetings.
Angel Sandoval.
Additionally we want to connect a Graphic HMI, and monitorear the curve of pressure and injection speed, we are planning to use the EZTouch of Automation Direct that has the communication protocol Modbus RTU.
Please send us their comments and suggestions.
Greetings.
Angel Sandoval.