Internet PLC Forum

General => Technical support => Topic started by: KenFend on March 27, 2007, 03:59:10 AM

Title: Control Logix CH0 Setting
Post by: KenFend on March 27, 2007, 03:59:10 AM

I have a system with two identical AB Controllogix processors, 1756-L1, v. 13.27.  I need to change Channel 0 to user mode.  I had no problem with the first unit, I could change the serial port setting on line, no problems.  On the second unit, after I change the serial port setting, and close the window, I receive an error "Invalid Attribute Value", and my setting are discarded, reverting to the original.  I have check the baud rate, etc, and the user protocal setting, they match the first unit.  Called AB tech support yesterday, but received no solution.  I can change the settings on the offline program, but when I download, the settings are rejected.

Thanks for any help in getting me out of this warehouse and back to my family.

Ken

Title: Re:Control Logix CH0 Setting
Post by: support on March 27, 2007, 07:21:04 AM

Unfortunately this is not a forum to support A-B PLCs. This forum is strictly for supporting TRi range of PLC products. There is not much we can do for you here other than to advise you to continue to contact A-B tech support for an answer. Good luck!