Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - shsumeet

Pages: [1]
1
Technical support / Re:XServer with Trilogic5.3
« on: April 03, 2005, 09:16:17 AM »
I put in the right IP address.. The Trilogi software does connect to X server innitially. However after some time it does not remain connected and gives the error.

There is no problem when using the default java applet -
http://172.25.25.3/xhmi1.htm

Sumeet


2
Technical support / XServer with Trilogic5.3
« on: April 02, 2005, 04:57:52 PM »
Hi
I recently purchased the PLC starter kit (1STK) and the X Server. I plugged the X Server to the PLC as explained. Everythign seems to be fine except that when I run my trilogic 5.3 in Online Monitoring mode, the communication ends after a random delay.

I get the following error

Please check the following
1.PLC ID =01 is connected to the server
2. Check that ID is correct

What could be wrong?

Sumeet

Pages: [1]