Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TravisB

Pages: 1 2 [3]
31
Technical support / Way to advance the time/date in the simulator
« on: March 23, 2012, 03:43:13 PM »
I have some BASIC code which takes action based on the change of day, and month, and year at midnight each day. I'm wondering if there is a way I can run the simulator and advance the date/time to midnight, to the end of the month, and to the end of the year so I can see if all of my actions are occuring as expected.

32
Technical support / Re:FMD88-10 with SSI Media Sensor
« on: March 12, 2012, 09:45:17 AM »
It turns out there was a leak in my pressure system, the error was my own.

33
Technical support / FMD88-10 with SSI Media Sensor
« on: March 09, 2012, 02:38:13 PM »
I have an FMD88-10 with a simple program running successfully. I have attached an SSI P51 3PSI Gauge pressure sensor.
I have the senors set-up to calibrate with the positive (red) going to the AC/DC transformer, the ground (black) going to the analog ground (0V (gnd)) and the white wire going to AD2.

When the pressure applied to the sensor changes (increases or decreases) the sensor reacts appropriately, but then slowly returns to the same reading from before the pressure change.

I have in the past worked with Druck pressure transducers with Campbell Scientific dataloggers. My assumption was that the present set-up would work similar to the previous set-up I have experience with.

If this is all explained in the archives feel free to point me in the correct direction. I've tried searching, but havn't found anything yet.

Pages: 1 2 [3]