1
Technical support / Re:Running program from PC
« on: January 03, 2012, 11:26:54 PM »
Excellent.
Thank you very much.
Abello
Thank you very much.
Abello
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical support / Running program from PC
« on: January 03, 2012, 04:31:24 PM »
I've seen an example project run from the PC using the simulator run setup to actuate various outputs for testing/"show-n-tell". At the time I was just being introduced to PLCs so I didn't bother to ask how they set it up.
Is that possible with an H-series PLC with the wintrilogi program (v3.5)?
Thanks much,
Abello
Is that possible with an H-series PLC with the wintrilogi program (v3.5)?
Thanks much,
Abello
3
Technical support / Re:Loading PLC program from laptop to PLC
« on: September 07, 2011, 09:31:47 AM »
Support,
In setting up the COM port through the WinTrilogi software, does my laptop need to be connected to my PLC or am I just finding the correct port information and putting it into my program?
***EDIT***
Think I got it all figured out. Sorry.
Thanks.
In setting up the COM port through the WinTrilogi software, does my laptop need to be connected to my PLC or am I just finding the correct port information and putting it into my program?
***EDIT***
Think I got it all figured out. Sorry.
Thanks.
4
Technical support / Re:Loading PLC program from laptop to PLC
« on: September 06, 2011, 11:22:11 AM »
H-series. Thank you for the information!
5
Technical support / Loading PLC program from laptop to PLC
« on: September 05, 2011, 06:00:19 PM »
Hello all,
I've finished programming and building my project that my PLC will control. Now I want to finally dive into testing and I'm not real sure how to download the program onto the PLC. I get as far as going to the controller tab > Download program to PLC, then it asks me for 'input PLC's address' and i'm not sure what that value is?
I apologize if this is a boneheaded question!
Thanks.
I've finished programming and building my project that my PLC will control. Now I want to finally dive into testing and I'm not real sure how to download the program onto the PLC. I get as far as going to the controller tab > Download program to PLC, then it asks me for 'input PLC's address' and i'm not sure what that value is?
I apologize if this is a boneheaded question!
Thanks.
6
Technical support / Re:H-Series Output Source Clarification
« on: September 07, 2010, 07:48:10 PM »
Thanks. Does this mean I need to provide an external 12V Power source and an external 30V power source for these outputs?
7
Technical support / H-Series Output Source Clarification
« on: September 06, 2010, 10:10:14 PM »
Hello All,
I'm new to PLC control and building my first machine using a PLC. I just purchased a T28H-Relay and while looking at the manual I see it says "Voltage Source 0-250V (DC/AC)." Does that mean for example I can have a solenoid output operate at 12VDC and another operate at 30VDC?
Thanks
I'm new to PLC control and building my first machine using a PLC. I just purchased a T28H-Relay and while looking at the manual I see it says "Voltage Source 0-250V (DC/AC)." Does that mean for example I can have a solenoid output operate at 12VDC and another operate at 30VDC?
Thanks
Pages: [1]