Internet PLC Forum

General => General Discussions => Topic started by: Charlie on October 22, 2004, 03:04:36 PM

Title: Connection Problems
Post by: Charlie on October 22, 2004, 03:04:36 PM

Having troubles connecting my PLC to my PC. I've configured and set up all the drivers in RSLinx Lite, and using them with RSLogix 500. But when I try to connect, I get this error message: No response from processor at selected path/node! DiagnosticStatus failed at: 0x4. Any help on what I can do to get connected?

Title: Re:Connection Problems
Post by: tipster on November 16, 2004, 10:06:56 AM

DEpending on how you configured your drivers, make sure the selected driver is running when trying to go online,
Also verify that you r driver is the correct one for the Processor you are trying to communicate to. Also , the processor must have the channel configured for system communications