46
Technical support / Re: Communication
« on: January 31, 2003, 07:55:27 AM »
Leon,
Do you remember the connection that you use when test the RS485-Fiber converter? They have 3 terminal screws. one (+), one (-) and the last one is marked with (C). I don't know if the C should be connected to ground. I check the master T100MD connected directly to the H-slave and it works properly. But, when I try to connect them trought the fiber optic, they don't have communication however the Tx and Rx leds are bipping (on, off).
Philip.
Do you remember the connection that you use when test the RS485-Fiber converter? They have 3 terminal screws. one (+), one (-) and the last one is marked with (C). I don't know if the C should be connected to ground. I check the master T100MD connected directly to the H-slave and it works properly. But, when I try to connect them trought the fiber optic, they don't have communication however the Tx and Rx leds are bipping (on, off).
Philip.