Show Posts
1
Technical support / MBTCP Time-out was 0 , what does it do
« on: November 14, 2022, 10:06:53 AM »
I have an HMI connected to a FX1616-Ba using modbus over ethernet, I am also trying to add an extra serial port by doing a TCPconnect to a moxa 5230, when I connect (tcpconnect) to the moxa, the hmi complains about a lack of connection. increasing this value from 0 to 2 improves it greatly but not eliminates the problem. what happens if I take this value even higher?
many thanks
Graham
many thanks
Graham