Show Posts
1
Technical support / analog output
« on: July 11, 2010, 11:38:19 PM »
how to set analog outptut in plc t100md+1616?
i try to use this program :
SETDAC 1,2048
that program should give current output 10 mA, but when i use multimeter to measure the current output between D/A #1 and GND, there are nothing measured current.
i try to use this program :
SETDAC 1,2048
that program should give current output 10 mA, but when i use multimeter to measure the current output between D/A #1 and GND, there are nothing measured current.