Author Topic: R/W DM  (Read 10774 times)

dan

  • Newbie
  • Posts: 47
    • View Profile
R/W DM
« on: April 04, 2006, 08:53:52 AM »
Hi,

There is any way that I can Read/W a block of DM?
Now I'm using to R/W one location per command but I would like to do this faster and easier (lot of code just to R/W DM)

Thank you,

Dan

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re:R/W DM
« Reply #1 on: April 04, 2006, 09:41:07 AM »
You can use the "@ddRDnnnnccccff*" command to read a block of DM. Check the command format on page 4-21 of the T100MD+ User's Manual.
Email: support@triplc.com
Tel: 1-877-TRI-PLCS

Joel Moore

  • Full Member
  • Posts: 128
    • View Profile
Re:R/W DM
« Reply #2 on: April 07, 2006, 12:53:48 AM »
What timing!  I came here to ask this very question.   I've never even looked in the Omron section of the manual.

I still have one question, though.  Can these be mixed with native host commands?  The wording the manual makes it seem like you can but I just wanted to be sure before I implement these.

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re:R/W DM
« Reply #3 on: April 09, 2006, 01:05:01 AM »
Yes, you can mix native and OMRON protocol together. They are compatible in command format and FCS computation. OK.. we admit that the native command is modelled after OMRON host link commands  ;)
Email: support@triplc.com
Tel: 1-877-TRI-PLCS

Joel Moore

  • Full Member
  • Posts: 128
    • View Profile
Re:R/W DM
« Reply #4 on: April 11, 2006, 07:21:19 AM »
Heh.  Yeah, after investigating further I noticed host mode was just a superset of the Omron commands.  Very clever.  :)