NO compilation or PLC transfer

[dutch_CAT]

When I press F8 to test-compile the program nothing happens
The program does not crash but I do not get a compilation window.
Trying to transfer to the PLC, Ctrl.+T gives the same result.
Tried to restart the software and the computer to no avail.

[support]

Which version of software (DOS or Windows)

Does this happen to every program? If it happens only to a specific program then you can email the program to support@tri-plc.com to check out. Most likely there is an exception occur. You can see the error message if you start up the program from command prompt. E.g.

C:\TRILOGI\TL5> java -jar TL53.jar

A TRiLOGI 5.3 window will open together with a command prompt window and when there is an error the command prompt window will show the actual exceptions.