With my application running on the PLC I shut down Trilogic and TLServer, remove the serial cable from the PLC, remove and reapply power to the PLC.
The PLC will not reboot into the application, it remains in Pause Mode. I reattach the serial cable and start TLServer and Trilogic. When I try to connect to the PLC, the ID of the PLC is shown as HEX82 (not 01 as was assigned). When I try to transfer my application to the PLC, I am again asked for a Password.
I then apply the KILL command and I can get everything working again until I try to reboot the PLC, and again it fails to restart.
I don't think the KILL command clears the EEPROM sufficiently.
What next?
Alan