Author Topic: Ladder printing problem  (Read 13496 times)

lloyd.maclean

  • Newbie
  • Posts: 7
    • View Profile
    • lloyd's page
Ladder printing problem
« on: April 21, 2004, 10:19:24 AM »
I am having trouble printing the ladder portion of my program.  The very right edge of the coil names is always cut off.  I have tried to adjust the "width" as well as the printer scaling and have tried several different printers all with no effect.  Is there a solution????
Thanks,
Lloyd

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re:Ladder printing problem
« Reply #1 on: April 21, 2004, 02:43:04 PM »
What version of TRiLOGI program are you using? Try to upgrade to the latest TRiLOGI (latest is version 5.31) where we have fixed some of these printing issues.
Email: support@triplc.com
Tel: 1-877-TRI-PLCS

lloyd.maclean

  • Newbie
  • Posts: 7
    • View Profile
    • lloyd's page
Re:Ladder printing problem
« Reply #2 on: April 22, 2004, 11:20:19 AM »
I can't seem to find where I can update the software.  Is there a link?
Thanks,
Lloyd

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re:Ladder printing problem
« Reply #3 on: April 22, 2004, 02:33:54 PM »
There is an "upgrade.htm" document on your CD-ROM which contains the link, username and password for you to obtain an upgrade to the latest TRiLOGI software.
Email: support@triplc.com
Tel: 1-877-TRI-PLCS