General > General Discussions

HSC in cusfn

(1/1)

artkraft:
what is the purpose of // in a cusfn.
 I am measuring the thickness of my material with an encoder. Desired control thickness is set with HMI and stored in DM[309]. When HSC2 < SV I want to send step pulses until it is > SV.
CusFn #13 see attached file.

support:
// is an alternative marker for COMMENTS. It is the same as single quote or REM. This is borrowed from C++. You can also use the /* and */ to comment out an entire block of codes. This is also borrowed from C/C++ language.

BetterBath:
I learned a little c++, so this topic seemed a bit familiar to me. Thank you for sharing.
Junk removalPet sitting Port St Lucie, FlPressurewashingpowerroofinghandyman

Navigation

[0] Message Index