Setting a DM location = to a counter value

[tobor0216]

I am wondering how to set a DM location = to a counter. The reason I am looking to dp this I want to read my counters into a mDM location in case of a pwr failure, I can then write them back to the counters and I do not lose any information.

Thanks Paul

[support]

E.g. DM[10] = CTRPV[1]

or

DM[1000] = CTRPV[5]

[tobor0216]

This works, but the problem is when I reset the PLC or remove the power, the memory locations are cleared.

[garysdickinson]

You can make the DM[] array act as if it is non-volatile using a couple of different methods:

• If you have the MX-RTC battery backed clock calendar option it is possible to make the DM[] behave as it is is non-volatile.  This requires both the MX-RTC module and a dip-switch setting on the PLC board.
• Copy the values that you want to save into the EEPROM and reload the DM[] from EEPROM at power up/reset

I use the following code to copy the first 96 entries of DM[] into EEPROM at addresses 1 to 96:

    FOR I = 1 to 96
      SAVE_EEP DM,I
    NEXT


I use the following code to reload DM[] when the PLC is reset:

   for i = 1 to 96
      dm=LOAD_EEP(i)
   next