Hi,
I have a T100MD1616 r33 with the RTC MODULE that has been working OK for a long time, now I try to change the program and set the E-mail function to get reports it does not accept and program. Right now the machine is working since I had another one in stock so I just loaded with the program.
In my office now I am testing the one that is failing and have these problems.
First the PAUSE LED was on. I switch Dip4=on, transfer the program (9800 Baud) Ok but none of the Output were working.
Change the BAUD to the normal 38400 checked no luck.
I download a simple program to test it:
I1 activate dcuf1 and i2 activate dcfn2.
dcfn1:
C$ = "SET-OUT3"
G$=C$
IF STRCMP (G$,C$)=0 THEN
SETBIT OUTPUT[1],2
CLRBIT OUTPUT[1],3
ENDIF
dcuf2:
C$ = "SET-OUT4
IF STRCMP (G$,C$)<>0 THEN
SETBIT OUTPUT[1],3
CLRBIT OUTPUT[1],2
ENDIF
Transfer the program ok.
When I try to monitor it, I have:
If I activate I1, Warning: Run time error in Fn#1 ERROR.Illegal memory access
If I activate I2, Warning: Run time error in Fn#2 ERROR.Illegal memory access
I close those warnings and then shows:
no response from node 3, Please check the following:
1 PLC ID=03 is connected to server
2 Check that the ID is correct.
I am using the COM1 and if I test the serial comms everyting ok.
I did remove the RTC MODULE and did again all the tests. Now I have THE PLC GOES TO PAUSE EVERYTIME I TRY TO RUN THE PROGRAM AND SHOWS:
Warning: PLC Program failed checksum test (corrupted) please re-transfer the program to PLC.
I did a few times with the same result, later, I have:
Warning: Runtime error FN#1 Error: Illegal OPCODE- Please inform to the Manufacturer.
Is it any way to fix this plc?
Thanks
PHILIP
