Author Topic: Analog Device  (Read 12435 times)

shahzad akram

  • Newbie
  • Posts: 4
  • I'm a llama!
    • View Profile
Analog Device
« on: June 12, 2008, 02:33:34 AM »
sir
   I have 4832 tri-PLC.I want to hook analog device with 0 to10 volt. can you advive me how can i connect with them.

support

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3174
    • View Profile
    • Internet Programmable PLCs
Re:Analog Device
« Reply #1 on: June 12, 2008, 10:24:24 AM »
You can use two 10K ohm resistors in series and connect to the 0-10V input, then tap the center of the two series resistor and the voltage will be divided by two, which means 0-5V.

This technique is already described in the PLC's installation guide (white cover thin booklet). Pleas refer to it for the wiring diagram.
Email: support@triplc.com
Tel: 1-877-TRI-PLCS