Stepper Motors Not Working!

[sntang]

Hi, need some stepper control advice!

I wrote 2 function to control two stepper motors running at the same time at different direction:

Funtion M1:
STEPSPEED 1,1000,20
STEPMOVE 1,500,8

Function M2:
STEPSPEED 2,1000,20
STEPMOVE 2,-500,9

When I activate both function together only one motor managed to move.

I'd tried run both motors seperately (Out#5, Out#6) on seperate program without any problem. So I can ruled out the motor driver or program error.

Did anyone have similar experience? Please advice. Thanks.

[support]

I tried out your program and managed to get pulses from both output #5 and #6 simultaneously. Did you observe the pulse output from both your output #5 and #6?

Since I don't have two stepper motor driver on hand  I observed the wave forms on an oscilloscope but did not notice any unusual pattern. So I both channels should be able to work simultaneously. They are of different direction since one is +ve direction and another in -ve direction so their respective direction output (#1 and #2) will be turned ON/OFF accordingly.